Sony HDR-CX130E Fiche technique Page 56

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 72
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 55
56
GB
Additional information
Troubleshooting
If you run into any problems using your
camcorder, follow the steps below.
Check the list (p. 56 to 58), and
inspect your camcorder.
Remove the power source, attach
the power source again after about 1
minute, and turn the camcorder on.
Press RESET (p. 67) using a pointed
object, and turn the camcorder on.
If you press RESET, all settings,
including the clock setting, are reset.
Contact your Sony dealer or local
authorized Sony service facility.
Your camcorder may be required to initialize
or change the current internal memory
(HDR-CX160E/CX180E) of your camcorder,
depending on the problem. In the event of
this, the data stored on the internal memory
will be deleted. Be sure to save the data on the
internal memory on other media (backup)
before sending your camcorder for repair. We
will not compensate you for any loss of internal
memory data.
During repair, we may check a minimum
amount of data stored on the internal memory
in order to investigate the problem. However,
your Sony dealer will neither copy nor retain
your data.
S
ee the “Handycam” Handbook (p. 55) for
details on the symptoms of your camcorder,
a
nd “PMB Hel
p” (p. 37) on connecting your
camcorder to a computer.
The power does not turn on.
Attach a charged battery pack to the
camcorder (p. 10).
Connect the plug of the AC Adaptor to the
wa
ll outlet (wa
ll socket) (p. 12).
The camcorder does not operate even
when the power is set to on.
It takes a few seconds for your camcorder to
be ready to shoot after the power is turned on.
This is not a malfunction.
Disconnect the AC Adaptor from the wall
outlet (wall socket) or remove the battery
pack, then reconnect it after about 1 minute.
If your camcorder still does not work, press
RES
ET (p. 67) u
sing a pointed object. (If you
press RESET, all settings, including the clock
setting, are reset.)
The temperature of your camcorder is
extremely high. Turn off the camcorder and
leave it for a while in a cool place.
The temperature of your camcorder is
extremely low. Leave the camcorder with the
power turned on. If you still cannot operate
your camcorder, turn off the camcorder and
take it to a warm place. Leave the camcorder
there for a while, then turn on the camcorder.
Your camcorder gets warm.
Your camcorder may become warm during
operation. This is not a malfunction.
The power abruptly turns off.
Use the AC Adaptor (p. 12).
Turn on the power again.
Charge t
he battery pack (p. 10).
Pressing START/STOP or PHOTO does not
record images.
Press MODE to turn on the (Movie) or
(Photo) lamp.
Your camcorder is recording the image you
have just shot on the recording media. You
cannot make any new recordings during this
period.
The recording media is full. Delete
unn
ecessary images (p. 32).
Total number of movie scenes or photos has
exceeded the recordable capacity of your
c
amcorder (p. 59). Delete unnecessary images
(p. 32).
Vue de la page 55
1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 71 72

Commentaires sur ces manuels

Pas de commentaire