Sony PSP-2006 Manuel d'utilisateur télécharger pdf (Page 16)

Before requesting service

, There may be too much distance between the system and the

access point or, when in ad hoc mode, the system and the other

player.

, Check that the network settings are correct. Refer to the

instructions supplied with the network equipment and by your

Internet service provider to make the correct network settings.

, Depending on the access point setting, you may need to enter the

system's MAC address. You can check the MAC address under

(System Settings) "System Information".

, When communicating with another system in ad hoc mode, both

systems must be set to the same channel. You can check the

currently set channel under (Network Settings) "Ad Hoc

Mode".

, If a device that causes radio interference such as a microwave oven

is nearby, system communications may not work properly.

The Web page won't display properly.

, Some Web pages may not display properly.

The system or AC adaptor is warm.

, During use, the system or AC adaptor may become warm. This is

not a malfunction.

, When the communication function is being used, the system may

become warmer than during normal use. This is not a malfunction.

The system is turned on, but does not operate.

, Check that the system is not in hold mode. If it is, slide the power/

hold switch up to clear hold mode.

The system does not function properly.

, Static electricity and other similar occurrences may affect the

system's operation. After unplugging the AC power cord from the

electrical outlet and disconnecting any other cables, remove the

battery pack and AC adaptor, wait for about 30 seconds and then

restart the system.

, Slide the POWER/HOLD switch up and hold it for at least three

seconds until the power indicator turns off. The system will be

completely turned off. Then turn on the system again.

The date and time are reset.

, If the battery is not recharged and runs out, or if the battery pack

is replaced, the system date and time settings may be reset. Follow

the on-screen instructions to set the time and date.

The PSP® system is not recognized by the PC when

connected using a USB cable.

, Is Memory Stick Duo™ media inserted in the PSP® system?

, Check that an operating system that supports USB mass storage

class is installed in the personal computer in use.

, When using a USB hub or other devices, depending on the

operating environment of the PC, the Memory Stick Duo™

inserted in the system may not be recognized by the PC. Try

connecting the system directly to the PC using a USB cable.

, If "USB Charge" under (System Settings) is set to "On", the

device may not be recognized.

, When a USB cable is used, select (USB Connection)

under (Settings) after connecting the PSP® system to the PC.

The connected USB device is not recognized by the PSP®

system.

, Check that the USB connector on the top of the system is clean.

Try wiping it with a soft, dry cloth.

Other issues

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Sony PSP-2006 Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour PC/postes de travail Sony PSP-2006