Sony STR-GX900ES Manuel d'utilisateur télécharger pdf (Page 28)

Programirimg the Remote Control

After programming

Be sure to test that the component really works with the

programmed signals.

How many signals can you store in memory?

You can store approximately 60 signals, depending on the

format of the signal being used.

Memory capacity

If the LEARN indicator does not blink or light in step 3-(i) or

(D, this indicates that the memory capacity is full. In this

case, clear the signal stored in that button following the

procedure described in "To clear a programmed signal" and

program again from the beginning. When programming,

avoid the following conditions.

• Placing the remotes too far apart from each other.

• Exposing the remotes to intense light such as of invertor

fluorescent lamp.

• Receiving infrared signals of another appliance's remote.

Notes on programming

• Remote control signals of components of manufacturers

other than Sony can be programmed only when they are

compatible with the infrared wireless remote control

system. Since the programmable remote can "learn" only

the signals output from another remote, it cannot control

components that do not use a remote.

• Do not attempt to use the programmable remote with an

air conditioner or other household appliance.

• Note that there are some special remote control signals

that cannot be programmed.

• The SYSTEM CONTROL/FUNCTION button of this

remote does not work for thex)ther components even if

their signals are programmed.

Programming a New Signal onto a Previously

Programmed Button

Follow the programming procedure described on page 27.

The previously programmed signal is cleared and replaced

by the new signal.

To clear a programmed signal

1 Press the LEARN button with a bail-point pen, etc., so that

the LEARN indicator lights up.

2 Press the button to be cleared while pressing the

BACKGROUND button until the LEARN indicator goes

off.

To program a signal onto the • button for

recording

It is not possible to operate any component with only the #

button. You have to program the record standby signal and

record start signal under the 0 + ► button on the receiver's

remote. With a tape deck, you can also program the signal

under the • + button (in the reverse direction).

Notes on batteries

If the LEARN indicator does not light when a button is

pressed, this means that the batteries are low.

When the batteries are low, the remote can no longer operate

the unit and programming becomes impossible.

If this happens, replace both batteries with new ones. We

recommend you use alkaline batteries for extended use.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 49 50

Commentaires sur ces manuels

Pas de commentaire

Sony STR-GX900ES Manuel d'utilisateur Page 28

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Sony STR-GX900ES