Sony RM-VL700T Manuel d'utilisateur télécharger pdf (Page 17)

17

GB

5 Press and hold the button

on the other remote control,

until both the SET indicator

and the Component Select

button lights up again.

During data transfer, only the

SET indicator stays lit, and the

Component Select button turns

off.

After data transfer is complete,

the Commander returns to its

state in Step 3.

If the SET indicator flashes five

times

It means that “learning” is incomplete.

Repeat steps 4 and 5.

6 Repeat Steps 4 and 5 to

“teach” functions to other

buttons.

To “teach” another

component’s remote control

signal

After positioning the two remote

commanders as in Step 1 on page

15, press the corresponding

Component Select button, and then

follow Steps 4 and 5 to perform

Learning.

7 Press SET to finish setting.

Notes

•If you do not perform Learning steps

within 20 seconds at any point during

the process, Learning mode ends.

•If you do not perform Step 5 within

10 seconds after Step 4, the learning

procedure returns to Step 3. Repeat

Step 4.

To cancel setup, press SET.

If the Commander does not

seem to be working

If the “learned” button does not

operate properly, “teach” once again.

(For example, if the volume becomes

very loud after pressing 2 + only

once, noise may have interfered during

the Learning procedure.)

If you set a component code

after “learning” a signal

If you have programmed any signal on

a button by the Learning function, that

signal will work even after you set a

component code.

Note on the REC z signal

You can only “teach” to one button at a

time. Therefore you cannot teach a

sequential button operation (for

example REC z + B) to a single button

on the Commander. In this case,

“teach” the functions of each button on

your component to the Commander.

Continued

during data

transfer

data transfer

complete

remote control

of component

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 79 80

Commentaires sur ces manuels

Pas de commentaire