9-936-299-01 (1)Multi-Room Distribution Systemfor Sony Digitai Sateiiite ReceiverInstallation ManualDIGITAL SATELLITE SYSTEMMRD-D1© 1995 by Sony Corpo
Connecting the Remote TVs1 MRD-Dl will support (provide signal for, and IR remote control of two video sources for) five remote TV locations. Connect
Setting up and Tuning the ModulatorPerform the following steps after your multi-room distribution system has been connected properly.1 Connect the ou
Note• INPUT 2 must be higher than INPUT 1 when using CATV channels, and INPUT 1 and INPUT 2 must be separated by at least one unused channel.•
System DiagramA/V CableDSS Receiver- Audio/ Video Out«TfUITE.« ^ ▼ ▼ ▼nil 0 II ® .^.™cHs:©"*lllllllllllll “y* a ® ¿ IAVÍW5 • ó ® ® ® ® @©-□•/&apo
Common QuestionsCan the modulator be connected to a remote TV without using an IR target?Yes, but you won't have remote control capability. You c
SpecificationsGeneralSize (H/W/D)MassPowerPerformanceSignal InputsSignal OutputsRF carriersRF Power OutputAntenna Isolation Video PerformanceSignal to
Limited WarrantyIf this product should prove defective in workmanship or material during the period of one (1) year from the date of original purchase
CautionThis unit is not designed for outdoor use and should be installed in a clean, dry location.Radio Interference InformationThis equipment has bee
ContentsIntroduction...4Inspection...
IntroductionCongratulations on selecting the MRD-Dl multi-room distribution system for use with your Sony brand DSS® (Digital Satellite System). With
InspectionYour MRD-Dl multi-room distribution system consists of a modulator unit, a power supply, two IR emitter assemblies, an IR target, four mount
Preparation for UseBefore installing your MRD-Dl, please read the following brief discussion of its parts and what they do:Modulator UnitThe modulator
Installation Instructions1 Make certain that your present system is functioning correctly prior to installing MRD-Dl. Ensure that all antenna or cabl
Fasten the modulator unit to the desired location using the mounting screws provided with the unit. The orientation is not critical. Mounting that ena
9 Connect the IR emitters to the modulator unit. With firm pressure, place one of the adhesive backed IR emitters over the remote sensor on the DSS r
Commentaires sur ces manuels