Sony KDL-52XBR6 Manuel d'utilisateur télécharger pdf (Page 4)

− 4 −

Additional Information for Using Sony Wall-Mount Bracket (SU-WL500)

3 Adjust the angle of the Mounting Hook using the hexagon wrench supplied

with the Wall-Mount Bracket.

When installing the TV parallel to the wall (0 degrees), adjustment of the Mounting Hook angle

(procedures



and



below) is not necessary. Make sure that each arm base X is screwed in securely.

 Remove the two screws from the arm base X of the Mounting Hook. Choose the holes

corresponding to the desired angle (5, 10, 15 or 20 degrees).

 Adjust the angles of the top Y and bottom Z arm to t the corresponding hole, and rmly

secure each arm using the two screws removed in the previous procedure .

Hexagon

wrench

✍

• Be sure to adjust the right and le arms to the same angle.

• Make sure that the two arm bases are screwed in securely.

CAUTION

Be careful not to pinch your ngers when adjusting the angle of the Mounting Hook.

4 Remove the screws from the back of the TV.

Do not remove any other screws from the TV.

5 Lift the TV o the stand. Make sure that you carry out this task with at least two

or three people.

Do not attempt to li the TV by yourself.

Step 5: Installing the TV on the wall

Refer to the Instructions for SU-WL500.

✍

• When you put the TV back on the stand, reverse the above steps.

• When moving the TV, do not squeeze the bottom of the front panel too strongly.

• Remove the screws or install the Mounting Hook on a stable and level surface.

1 2 3 4

Pas de commentaire

Sony KDL-52XBR6 Manuel d'utilisateur Page 4