Sony MDX-C800REC Manuel d'utilisateur télécharger pdf (Page 22)

22

1

1

23

2

4

3

Track

number

Original

tracks

Erase

Erase track B

Using a timer to stop recording

— Timer-off recording

You can set a timer so the unit will continue

recording the radio programme after you turn

off the ignition and leave the car.

1 Press (OPEN) and insert the MD to be

recorded on.

2 Tune in the desired station (page 30).

3 Press (MD REC).

4 Press (MD REC) again to start recording.

5 Press (REC MENU) repeatedly until your

desired recording time appears.

Each time you press (REC MENU),

recording time increases, in increments of

10 minutes.

B 10 B 20 B … B 80 B off

During Timer-off recording, the unit keeps

beeping to indicate the state of the unit and

stops beeping when the recording is

completed. When you turn the ignition to

the ACC position and attach the front panel

again, “REC Complete!” appears on the

display if the recording is completed

successfully.

Notes

• Be sure not to start the engine of your car again

during Timer-off recording. Recording may fail.

• Frequent use of the Timer-off recording feature

may cause battery drain. Make sure that the

battery is well charged.

• The power aerial remains extended during

Timer-off recording. (The aerial retracts when

the recording is over.)

• The sound of the radio will be recorded on the

MD as you hear it during reception (including

any noise, distortion, and missing sound).

• When the optional DAB tuner unit XT-100DAB is

connected: you cannot record DAB programmes

with Timer-off recording feature. In such a case,

consult your nearest Sony dealer.

Editing an MD

By using the editing functions described

below, you can create your own original MD

albums.

Caution

Do not edit the MD while driving, as it diverts

your attention from the road.

Notes on editing

•“Protected” appears if the tab for record-

protection is open.

• Once you finish recording on or editing the MD,

be sure to eject the MD before you turn off the

ignition or disconnect the power-supply leads of

the unit. Editing and recording are completed

when the unit updates the TOC (Table of

Contents) information and then the MD is

ejected. The lamp located at the bottom of the

MD slot flashes during updating of the TOC

information.

• The (1) (REP), (2) (SHUF), (3) (PGM), (5) (AF),

(6) (TA) and (DSPL) buttons do not work during

edit mode.

Erasing a recording

— Erase function

You can erase a single track or all tracks at

once. You can erase a portion of a track as well.

Note

You cannot restore an erased track. Be sure to

confirm the selected track or tracks before erasing.

Erasing a single track

You can erase a track simply by specifying its

track number. When you erase a track, the

total number of tracks on the MD decreases by

one, and all the tracks following the erased one

are renumbered.

Example: Erasing track B.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 261 262

Commentaires sur ces manuels

Pas de commentaire