Sony PCV-R558DS Manuel d'utilisateur télécharger pdf (Page 55)

Removing, Installing, and Replacing Components

Installing a 3½” Internal Hard Disk Drive

Your system comes with an available bay to hold an additional 3½” hard

disk drive. The drive you install must not require front panel access. The

hard disk drive access light blinks when either internal drive is active.

Configure the jumpers on the new drive as a primary slave (see your

drive’s documentation for configuration instructions).

Disconnect the power cord from the computer.

Remove the cover (see “Removing the Cover” on page 22).

Remove the four screws (A in next diagram) that secure the drive

holder to the top of the chassis.

Before opening the system unit, save any open files, exit Windows, turn off

the power of the computer and all attached peripherals, and then unplug the

power cord.

KY0084.VSD

Drive connector

Power connector

Jumpers

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 117 118

Pas de commentaire

Sony PCV-R558DS Manuel d'utilisateur Page 55