Sony STR-DH720 Manuel d'utilisateur Page 38
- Page / 88
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
38
GB
D:\NORM'S JOB\SONY HA\SO120006\STR-
DH720_PMRF_05\4262412122_GB\GB04GET_STR-DH720-CEL.fm
masterpage: Left
STR-DH720
4-262-412-12(2)
Message list after Auto
Calibration measurement
Tip
Depending on the position of the subwoofer, the
measurement results may vary. However, there will
be no problems even if you continue to use the
receiver with that value.
You can customize the Auto Calibration by
selecting the calibration type you want.
1 Press GUI MODE.
After “GUI ON” appears on the display
panel for a while, the GUI menu appears
on the TV screen.
Press MENU if the GUI menu does not
appear on the TV screen.
2 Press V/v repeatedly to select
“ Settings”, then press or
b.
3 Press V/v repeatedly to select
“Auto Cal.”, then press or b.
4 Press B/b repeatedly to select
“Custom”, then press .
5 Press V/v repeatedly to select
the calibration type you want,
then press .
• Full Flat: Makes the measurement of
frequency from each speaker flat.
• Engineer: Sets to “the Sony listening
room standard” frequency
characteristics.
• Front Reference: Adjusts the
characteristics of all the speakers to
match the characteristics of the front
speaker.
• Off: Sets the Auto Calibration equalizer
level to off.
6 Press to confirm the
selected calibration type.
7 Follow steps 5 to 9 in
“Performing Auto Calibration”
(page 36).
Display and explanation
Error Code 31
The SPEAKERS is set to off. Set to other speaker
settings (page 9) and perform the Auto Calibration
again.
Error Code 32
None of the speakers were detected. Make sure that
the optimizer microphone is connected properly and
perform the Auto Calibration again.
If the optimizer microphone is connected properly
but the error code still appears, the optimizer
microphone cable may be damaged.
Error Code 33
• None of the front speakers are connected or only
one front speaker is connected.
• The optimizer microphone is not connected.
• Either the surround left or surround right speaker
is not connected.
• Surround back speakers or front high speakers are
connected even though surround speakers are not
connected. Connect the surround speaker(s) to the
SPEAKERS SURROUND terminals.
• The surround back speaker is connected only to
the SPEAKERS SURROUND BACK/FRONT
HIGH R terminals. When you connect only one
surround back speaker, connect it to the
SPEAKERS SURROUND BACK/FRONT HIGH
L terminals.
• Either the front left high or front right high speaker
is not connected.
Warning 40
The measurement process has completed with high
noise level detection. You may be able to achieve
better results if you try in a quiet environment again.
Warning 41
Warning 42
The input from the microphone is too big.
• The distance between the speaker and the
microphone may be too close. Set them apart and
perform the measurement again.
Warning 43
The distance and position of a subwoofer cannot be
detected. This may be caused by noise. Try to
perform the measurement in a quiet environment.
No Warning
There is no warning information.
Customizing the Auto
Calibration
- Multi Channel AV 1
- Receiver 1
- Owner’s Record 2
- About This Manual 4
- Table of Contents 6
- Supplied accessories 7
- Inserting batteries into the 8
- Front panel 9
- STR-DH720 10
- 4-262-412-12(2) 10
- Rear panel 12
- Remote control 13
- To control the receiver 14
- To control a Sony TV 15
- Getting started 17
- 1: Installing the speakers 18
- Connections 19
- 2: Connecting the speakers 20
- 3: Connecting the TV 22
- 4a: Connecting the video 23
- Notes on HDMI connections 24
- When connecting cords 25
- Connecting a PlayStation 3 28
- Connecting other equipment 29
- Notes on converting video 30
- To connect a recording 30
- 4b: Connecting the audio 31
- 5: Connecting the 32
- 6: Connecting the AC 32
- Preparing the Receiver 33
- Selecting the speaker pattern 33
- Before you perform Auto 34
- Calibration 34
- 1 Select the speaker pattern 35
- 3 Set up the optimizer 35
- Performing Auto Calibration 36
- 9 Disconnect the optimizer 37
- Customizing the Auto 38
- Using the menu 39
- 1 Press GUI MODE 40
- 3 Press TOOLS/OPTIONS while 40
- 2 +/– to adjust the volume 41
- Basic Operations 41
- 2 Press TOOLS/OPTIONS 42
- 3 Select “Name Input”, then 42
- 5 Repeat step 4 to input a 42
- Playing an iPhone/iPod 43
- To select the playback mode 44
- To operate the iPhone/iPod 45
- Notes on iPhone/iPod 45
- Playing a USB device 46
- 3 Press to select “USB” 47
- USB message list 48
- In case of poor FM stereo 49
- (Preset Tuning) 50
- Changing the AM tuning scale 50
- Selecting the sound field 52
- Music mode 53
- When headphones are 54
- Enjoying Surround Sound 55
- Resetting sound fields to 56
- 1 Press ?/1 to turn off the 56
- 2 While holding down MUSIC 56
- What is “BRAVIA” Sync? 56
- Preparing for the 57
- “BRAVIA” Sync 57
- Playing back equipment 58
- Enjoying the TV sound 58
- Turning off the receiver 59
- Enjoying movies with the 59
- (Scene Select) 60
- (INPUT MODE) 60
- Other Operations 60
- HDMI input assign 62
- Using the Settings menu 63
- Speaker Settings menu 64
- 1 Select the speaker on the 65
- 2 +/–. You can also 66
- Surround Settings menu 67
- EQ Settings menu 67
- Audio Settings menu 68
- HDMI Settings menu 68
- System Settings menu 69
- To return to the previous 70
- To exit the menu 70
- Adjusting Settings 71
- Reassigning the input 74
- Resetting the input 75
- 2 Release all buttons 75
- Precautions 76
- Troubleshooting 77
- 2 – on the 81
- To clear See 83
- Specifications 84
Produits connexes et manuels pour Récepteurs et amplificateurs Sony STR-DH720
(1 pages)
(68 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.612 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels