Sony HDW-1800 Manuel d'utilisateur Page 2
- Page / 119
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
2
To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or
moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified
personnel only.
THIS APPARATUS MUST BE EARTHED.
WARNING: THIS WARNING IS APPLICABLE
FOR USA ONLY.
If used in USA, use the UL LISTED power
cord specified below.
DO NOT USE ANY OTHER POWER
CORD.
Plug Cap Parallel blade with ground pin
(NEMA 5-15P Configuration)
Cord Type SJT, three 16 or 18 AWG
wires
Length Minimum 1.5m (4 ft .11in.),
Less than 2.5 m (8 ft .3 in.)
Rating Minimum 10A, 125V
Using this unit at a voltage other than 120V
may require the use of a different line cord
or attachment plug, or both.
To reduce the risk of fire or electric shock,
refer servicing to qualified service
personnel.
WARNING: THIS WARNING IS APPLICABLE
FOR OTHER COUNTRIES.
1. Use the approved Power Cord (3-core mains lead) /
Appliance Connector / Plug with earthing-contacts that
conforms to the safety regulations of each country if
applicable.
2. Use the Power Cord (3-core mains lead) / Appliance
Connector / Plug conforming to the proper ratings
(Voltage, Ampere).
If you have questions on the use of the above Power Cord
/ Appliance Connector / Plug, please consult a qualified
service personnel.
CAUTION
These servicing instructions are for use by qualified
personnel only. To reduce the risk of electric shock, do not
perform any servicing other than that contained in the
Operating Instructions unless you are qualified to do so.
Refer all servicing to qualified service personnel.
CAUTION
The apparatus shall not be exposed to dripping or
splashing and no objects filled with liquid, such as vases,
shall be placed on the apparatus.
CAUTION
The unit is not disconnected from the AC power source
(mains) as long as it is connected to the wall outlet, even if
the unit itself has been turned off.
For the customers in the U.S.A.
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause
harmful interference in which case the user will be
required to correct the interference at his own expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
All interface cables used to connect peripherals must be
shielded in order to comply with the limits for a digital
device pursuant to Subpart B of Part 15 of FCC Rules.
For customers in Canada
This Class A digital apparatus complies with Canadian
ICES-003.
For the customers in Europe
This product with the CE marking complies with both the
EMC Directive (89/336/EEC) and the Low Voltage
Directive (73/23/EEC) issued by the Commission of the
European Community.
Compliance with these directives implies conformity to
the following European standards:
• EN60065: Product Safety
• EN55103-1: Electromagnetic Interference (Emission)
• EN55103-2: Electromagnetic Susceptibility (Immunity)
This product is intended for use in the following
Electromagnetic Environment(s):
This symbol is intended to alert the user to
the presence of uninsulated “dangerous
voltage” within the product’s enclosure
that may be of sufficient magnitude to
constitute a risk of electric shock to
persons.
This symbol is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in
the literature accompanying the
appliance.
WARNING
- HDW-1800 1
- HDW-D1800 1
- Table of Contents 4
- 1-1 Features 7
- Chapter 1 Overview 7
- HDV (i.LINK) input (option) 8
- 1-3 Description of the 10
- Function Menu in this 10
- Location and Function of 11
- 2-1-1 Upper Control Panel 12
- 2-1-2 Lower Control Panel 13
- Video display mode 14
- Function display mode 14
- 2-1 Control Panels 15
- Input channel indication 16
- Data/Emphasis indication 16
- Headroom mark 16
- Audio level indication 16
- REM:20min 17
- 12 34 47 12 18
- 7 Search control section 20
- 2-1-3 Switch Panel 21
- KEY INHI 21
- CONTROL PANEL 21
- 2-2 Connector Panel 22
- REMOTE 1-IN(9P) 24
- REMOTE 2 PARALLEL I/O(50P) 24
- REMOTE 1-OUT(9P) 24
- VIDEO CONTROL (9P) 24
- TIME CODE 25
- MONITOR OUTPUT 25
- Preparations 26
- 3-2 Reference Sync 27
- 3-3 Setup 28
- 3-4 Superimposed 29
- Character Information 29
- Chapter 3 Preparations 30
- 3-5 Cassettes 31
- Recording and Playback 32
- 3,5 4,5 4,5126 33
- 4-1-3 Recording Procedure 35
- 4-2 Playback 36
- Normal playback 37
- Playback in jog mode 37
- Playback in shuttle mode 37
- 1 1,2,33 38
- Overview 39
- 7 3 3,4,61,4,2,5 40
- 5-1 Automatic Editing 42
- 5-1-2 Switch Settings 43
- 5-1-4 Setting Edit Points 44
- Chapter 5 Editing 45
- To modify an edit point 46
- To delete an edit point 46
- 5-1-7 Preview 47
- To start automatic editing 49
- 5-2 DMC Editing 50
- To exit the DMC edit mode 51
- To carry out the DMC editing 51
- 5-3 Special Automatic 52
- Editing Methods 52
- 5-3-4 Preread Editing 53
- Shot Mark Function 54
- 6-2 Shot Mark Operations 55
- To erase a shot mark 56
- To display the shot mark list 56
- Example of list display 56
- SHOT MARKER 57
- 6-2-4 Cuing Up to Shot Marks 58
- UMID Functions 59
- To set Stored Ownership 60
- To set the time zone 60
- 7-3 UMID Output and 61
- 7-3 UMID Output and Display 62
- Chapter 7 UMID Functions 62
- 8-1 Overview 63
- 8-2 Function Menu Item 64
- 8-2 Function Menu Item List 65
- Chapter 8 Function Menu 65
- P03: VID PROC 66
- P04: MISC-1 67
- P05: MISC-2 67
- Menu Pages (P100 to P118) 68
- P102: AUD MIX 69
- P104: SHOT MRK (Top page) 69
- P105: SHOT MRK (LIST page) 69
- P107: TCG SET 70
- P108: SETUP (TOP) 70
- P109: SETUP (SELECT1) 70
- P110: SETUP (SELECT2) 70
- P111: ERR.LOG (TOP) 70
- P118: SETUP (TC/UB SETTING) 72
- Setup Menus 73
- 9-2 Setup Menu 74
- Operations 74
- 9-2 Setup Menu Operations 75
- Chapter 9 Setup Menus 75
- B LEVEL (HD) Adjust the P 94
- R LEVEL (HD) Adjust the P 95
- B/PR tables 100
- Maintenance and 101
- Inspection 101
- ERROR-01 102
- REEL TROUBLE-1 102
- Error Message List 103
- 10-4 Moisture 104
- Condensation 104
- 10-5 Regular Checks 104
- 10-5-2 Maintenance Timings 105
- 10-6 About the LCD 106
- × 272 (V) 107
- Digital video system 108
- Digital audio system 108
- Analog audio (CUE) 108
- Digital Betacam playback 108
- MPEG IMX playback 109
- Processor adjustment range 109
- Input connectors 109
- Output connectors 109
- ∞ to –12 dBu at 8 Ω load 110
- Specifications 111
- Appendix 111
- About a “Memory Stick” 114
- Precautions 115
- Sony Corporation 119
Produits connexes et manuels pour Enregistreurs vidéo Sony HDW-1800
(20 pages)
(88 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.814 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels