Sony HWS-BTA2W Manuel d'utilisateur télécharger pdf (Page 17)

Transmitting

Check the following before operating the unit.

– The TX/RX switch is set to “TX.”

– The BLUETOOTH stereo audio receiving device’s BLUETOOTH function is on.

– Pairing of this unit and the BLUETOOTH stereo audio receiving device is complete.

1 Press the 1 button to turn on this unit.

2 Prepare the BLUETOOTH stereo audio receiving device to be

connected within 5 minutes after turning on this unit.

This unit turns off 5 minutes after turning on without making the BLUETOOTH

connection. If this unit turns off before the BLUETOOTH connection is made, turn it on

again.

Note

When using this unit as a transmitter, this unit tries to connect with either of the last two devices

recognized before. If this unit cannot make the BLUETOOTH connection with a paired device, pair

the device again, or try making the BLUETOOTH connection from the BLUETOOTH stereo audio

receiving device if possible.

3 Start playing on the stereo audio source device connected to this

unit.

4 Adjust the volume of the stereo audio source device connected to

this unit.

Turn up the volume of the stereo audio source device as high as possible to the extent

that sound is not distorted.

Note

Turn off the bass boost function or equalizer function. If these functions are on, sound may be

distorted.

Note

In the following cases, you need to make the BLUETOOTH connection again.

– The power of this unit does not turn on.

– The power of the BLUETOOTH stereo audio receiving device does not turn on, or the BLUETOOTH

function is off.

– The BLUETOOTH function of this unit or the BLUETOOTH stereo audio receiving device is in sleep

mode.

– The BLUETOOTH connection is not made.

To finish transmitting

Terminate the BLUETOOTH connection by any of the operations below.

– Turn off this unit.

– Turn off the BLUETOOTH stereo audio receiving device.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Pas de commentaire

Sony HWS-BTA2W Manuel d'utilisateur Page 17