Sony CCD-TR87 Manuel d'utilisateur télécharger pdf (Page 46)

Optimizing the recording condition

Use this to.itiiri' to diock the tape condition before recording, so that you can get tlie

best possible picture (ORC).

(1) While the camcorder is m Standby mode, press MENU to display the menu.

(2) Turn the control dial to select EH, then press the dial.

(3) Turn the control dial to select ORC TO SET, then press the dial.

"START/STOP KEY" flashes.

(4) Press START/STOP.

The camcorder takes about 10 seconds to check the tape condition and then

returns to Standby mode.

Each time you insert the cassette

Perform the above procedures.

Notes on the ORC function

•When you set ORC TO SET, the recording on the tape is erased for about 0.1 second so

that the camcorder can check the tape condition. Be careful when you use a recorded

tape.,The O.J second blank is erased if you record from the point where you set ORC

TO SET for more than 2 seconds, or if you record over the blank.

• You cannot use this function on a tape with the red mark on the cassette exposed.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 76 77

Pas de commentaire

Sony CCD-TR87 Manuel d'utilisateur Page 46