Sony CCD-TR910 Manuel d'utilisateur télécharger pdf (Page 46)

eturning to a pre-registered position

(CCD-TR910 only)

Using the Remote Commander, you can easily go back to the desired point on a tape

after playback. Use the tape counter. If the RC time code appears in the viewfinder, set

COUNTER to NORMAL in the menu system to display the tape counter.

(1) During playback, press COUNTER RESET at the point you later want to locate. The

counter shows "0:00:00" in the viewfinder.

(2) Press □ when you want to stop playback.

(3) Press ZERO MEM on the Remote Commander. The ZERO MEM indicator flashes in

the viewfinder.

(4) Press ◄ ◄ to rewind or press ► ► O fact-forward the tape to the counter's zero point.

The tape stops automatically when the counter reaches approximately zero.

Notes on the tape counter

• Something must be recorded on the tape in order for the tape counter to function.

Tape counter does not work on a blank tape.

• There may be a discrepancy of several seconds from the actual time.

Notes on ZERO MEM

• When you press ZERO MEM, the counter's zero point is memorized. Press ZERO

MEM again before rewinding to cancel the memory.

• This function is canceled automatically once the tape is rewound or advanced to the

point you pre-registered.

• ZERO MEM does not function during recording or playing back.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 79 80

Pas de commentaire

Sony CCD-TR910 Manuel d'utilisateur Page 46