Sony CCD-TR910 Manuel d'utilisateur Page 59

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 80
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 58
Tips for using the battery pack
This section shows you how you can get the most out of your battery pack.
Preparing the battery pack
Always carry additional batteries
Have sufficient battery pack power to do 2 to 3 times as much recording as you have
planned.
Battery life is shorter in a cold environment
Battery efficiency is decreased, and the battery will be used up more quickly, if you are
recording in a cold environment.
To save battery power
Turn STANDBY down when not recording to save battery power.
A smooth transition between scenes can be made even if recording is stopped and
started again. While you are positioning the subject, selecting an angle, or looking
through the viewfinder lens, the lens moves automatically and the battery is used. The
battery is also used when a tape is inserted or removed.
When to replace the battery pack
While you are using your camcorder, the remaining battery indicator in the viewfinder
decreases gradually as battery power is used up.
The minute indicator appears with the remaining battery indicator while recording.
c3-^a-^czi
When the remaining battery indicator reaches the lowest point, the tXi indicator
appears and starts flashing in the viewfinder.
When the <Xi indicator in the viewfinder changes from slow flashing to rapid flashing
while you are recording, slide the POWER switch to OFF on the camcorder and replace
the battery pack. Leave the tape in the camcorder to obtain a smooth transition between
scenes after the battery pack has been replaced.
The mark may start flashing even when the battery has enough power to last about 5 or
10 minutes.
Notes on the rechargeable batter/pack
Caution
Never leave the battery pack in temperatures above 140“F (60°C), such as in a car
parked in the sun or under direct sunlight.
The battery pack heats up
During charging or recording, the battery pack heats up. This is caused by energy that
has been generated and a chemical change that has occurred inside the battery pack.
This is not cause for concern and is normal.
59
Vue de la page 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 79 80

Commentaires sur ces manuels

Pas de commentaire