Sony DCR-TRV11 Manuel d'utilisateur télécharger pdf (Page 11)

Getting started

Charging the battery pack

Use the battery pack after charging it for your camcorder.

Your camcorder operates only with the “InfoLITHIUM” battery pack (M series).

(1) Open the DC IN jack cover, pulling the cover out a little and rotating. Connect

the AC power adaptor supplied with your camcorder to the DC IN jack on

your camcorder with the plug’s v mark facing the lens side.

(2) Connect the power cord to the AC power adaptor.

(3) Connect the power cord to the wall outlet.

(4) Set the POWER switch to OFF (CHG). Charging begins. The remaining battery

time is indicated in minutes on the display window.

When the remaining battery indicator changes to , normal charge is completed. To

fully charge the battery (full charge), leave the battery pack attached for about one hour

after normal charge is completed until FULL appears in the display window. Fully

charging the battery allows you to use the battery longer than usual.

After charging the battery pack

Disconnect the AC power adaptor from the DC IN jack on your camcorder.

Notes

•Prevent metallic objects from coming into contact with the metal parts of the DC plug

of the AC power adaptor. This may cause a short-circuit, damaging the AC power

adaptor.

•Keep the battery pack dry.

•When the battery pack is not to be used for a long time, charge the battery pack once

fully and then use it until it fully discharges again. Keep the battery pack in a cool

place.

Remaining battery time indicator

The remaining battery time you record with the viewfinder is displayed.

The remaining battery time indicator in the display window roughly indicates the

recording time with the viewfinder.

Battery pack

The battery pack is charged a little before it leaves the factory.

Step 1 Preparing the power supply

VCR

OFF

(

CHG

)

MEMORY

CAMERA

POW

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 151 152

Pas de commentaire

Sony DCR-TRV11 Manuel d'utilisateur Page 11