Sony DCR-TRV11 Manuel d'utilisateur télécharger pdf (Page 51)

Advanced Playback Operations

Note

If one day’s recording is less than two minutes, your camcorder may not accurately find

the point where the recording date changes.

In the mark

•The bar in the mark indicates the present point on the tape.

•The mark in the indicates the actual point you are trying to search.

If a tape has a blank portion between recorded portions

The date search function may not work correctly.

Cassette memory

The tape cassette memory can hold six recording date data. If you search the date

among seven or more data, see “Searching for the date without using cassette memory”

below.

Searching for the date without using cassette memory

(1) Set the POWER switch to VCR.

(2) Set CM SEARCH in

to OFF in the menu settings (p. 85).

(3) Press SEARCH MODE on the Remote Commander repeatedly, until the DATE

SEARCH indicator appears.

The indicator changes as follows:

DATE SEARCH t PHOTO SEARCH t PHOTO SCAN t no indicator

(4) Press . on the Remote Commander to search for the previous date or press

> on the Remote Commander to search for the next date. Your camcorder

automatically starts playback at the point where the date changes. Each time

you press . or >, your camcorder searches for the previous or next date.

To stop searching

Press x.

Searching a recording by date – Date search

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 151 152

Pas de commentaire

Sony DCR-TRV11 Manuel d'utilisateur Page 51