Sony KLV-20SR3 Manuel d'utilisateur télécharger pdf (Page 10)

Power Sources

Overloading

This TV set is designed to operate

on a 220-240V AC supply only.

Take care not to connect too

many appliances to the same

mains socket as this could result

in fire or electric shock.

Mains lead protection

Pull out the mains lead by the

plug. Do not pull on the mains

lead itself.

Wiring

Unplug the mains lead when wiring cables. Be sure to

unplug the mains lead for your safety, when hooking up.

Cleaning

Clean the mains plug regularly. If the

plug is covered with dust and it picks up

moisture, its insulation may deteriorate

and result in fire. Unplug the mains plug

and clean it regularly.

When not in use

For environmental and safety

reasons, it is recommended that

the TV set is switched off when

not in use - not left in standby

mode. Disconnect from the

mains.

Mains

Do not use a poor fitting mains socket. Insert

the plug fully into the mains. If it is loose, it

may cause arcing and result in fire. Contact

your electrician to have the mains socket

changed.

Moisture

Do not touch the mains lead with a wet

hand. If you plug/unplug the mains lead

with a wet hand, it may cause electric

shock.

Lightning storms

For your own safety, do not touch

any part of the TV set, mains lead

or aerial lead during lightning

storms.

Mains lead

If you damage the mains lead, it

may result in fire or electric

shock.

• Do not pinch, bend, or twist the

cable excessively. The core

lines may be bared or cut,

causing a short - circuit which

may in fire or electric shock.

• Do not convert or damage the

mains lead.

• Do not put anything heavy on the mains lead. Do not

pull the mains lead.

• Keep the mains lead away from heat sources.

• Be sure to grasp the plug when disconnecting the

mains lead.

• If the mains lead is damaged, stop using it and ask your

dealer or Sony service centre to exchange it.

Electric shock

Do not touch the TV set with wet hands. Doing so may

cause electric shock or damage the TV set.

Corrosion

If you use this set near the seashore, salt may corrode

metal parts of the TV set and cause internal damage or

fire. It may also shorten the life of the TV set. Steps

should be taken to reduce the humidity and temperature

of the area where the set is located.

Cable wiring

Take care not to catch your feet on the cables. It may

damage the TV set.

Installation

Do not install optional components too close to the TV

set. Keep optional components at least 30 cm away from

the TV set. If a VCR is installed in front or at the right

side of the TV set, the picture may distort.

Heat

Do not touch the surface of the TV. It remains hot, even

after the TV has been turned off for some time.

Oils

Do not install TV set in restaurants that use oil. Dust

absorbing oil may enter into the TV set and damage TV

set.

Water and moisture

Do not use the TV set near water – for example, near a

bathtub or shower room. Also, do not expose to rain,

moisture or smoke. This might result in fire or electric

shock. Do not use the TV set where insects may enter.

Disposal of the TV set

• Do not dispose of the TV set with general household

waste.

• The LCD contains a small amount of liquid crystal and

mercury. The fluorescent tube used in the TV set also

contains mercury. Follow your local ordinances and

regulations for disposal

continued...

Safety Information

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 161 162

Commentaires sur ces manuels

Pas de commentaire

Sony KLV-20SR3 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour TV LCD Sony KLV-20SR3