Sony MZ-N505 Manuel d'utilisateur télécharger pdf (Page 31)

31-GB

Adjusting the recording

level manually (Manual

Recording)

When you record, the sound level is

adjusted automatically. If necessary, you

can set the recording level manually

during both analog and digital recording.

1 Press REC while pressing X.

The recorder stands by for recording.

2 Press MENU.

3 Press . or > repeatedly until

“RecVol” flashes in the display, and

then press ENTER.

4 Press . or > repeatedly until

“Manual” flashes in the display, and

then press ENTER.

5 Play the source.

6 While observing the level meter in the

display, adjust the recording level by

pressing . or >.

Set the level so that the maximum

input lights up the fifth segment on

the level meter. If the sixth segment

lights up, lower the level by pressing

..

Recording does not start in this step.

If your source is an externally

connected component, be sure to cue

the source to the beginning of the

material to be recorded before you

start playback.

7 Press X again to start recording.

To switch back to automatic

level control

Select “Auto” in step 4.

Notes

• If you press x during recording operation, the

recorder will revert to automatic recording

level adjustment mode the next time you start

a recording operation.

• To set the recording level manually during

synchro-recording, do the procedure below.

1 Select “OFF” in step 3 of “Record an MD.”

(page 17).

2 Do steps 1 to 6 of manual recording

procedure (page 31). Then do steps 2 and 3,

and select “ON” in the synchro-recording

procedure (page 17).

Recording starts automatically whenever the

source sound is played.

• You cannot switch from

“Auto” to “Manual”

(or vice-versa) during recording.

REC

MENU/ENTER

./>/

N

X

Manual

REC15

fifth segment

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 131 132

Commentaires sur ces manuels

Pas de commentaire