Sony SAT-HD200 Manuel d'utilisateur télécharger pdf (Page 65)

8-6. Initializing the System

Signal Strength

Shows you up to three signal strength bars for Satellite Networks A, B, and C, in order to help you

adjust the dish to the correct position with the elevation, azimuth, and tilt values obtained from the

Your Location menu. While the maximum signal strength is 100, there will be no apparent difference

in picture quality between signal strengths of 60 to 85. The higher the signal, the less likely you are

to experience degradation when it rains or snows.

A transponder is a receiver/transmitter on the satellite. It receives signals from DIRECTV and retrans-

mits them to your dish. The DIRECTV

High-Definition Receiver is capable of displaying the signal

strength of most transponders by using the following method.

To see the signal strength:

1. Press the Menu button on the Remote Control to display the on-screen menu.

2. Select the DIRECTV

menu by pressing “ ” on the remote control.

3. Scroll down to Initial Setup using “

E”.

4. Move the highlight to the right with “

G” to select Signal Strength.

5. Press “ ” and the pop-up dialogue box will be displayed.

6. Move the highlight to select the desired transponder.

7. Press “ ” to return to Signal Strength.

8. Select Channel Setup using “

E” for the next step of initial setup.

NOTE

Although the initial setup is a

sequential process from Select Dish

to Channel Setup, each menu can

be accessed independently.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 103 104

Pas de commentaire

Sony SAT-HD200 Manuel d'utilisateur Page 65