Sony MHC-V11 Manuel d'utilisateur télécharger pdf (Page 37)

37

GB

Additional Information

MHC-V11.4-582-493-72(1)

The BLUETOOTH device cannot detect

the system, or “BT OFF” appears on

the display.

• Set the BLUETOOTH signal to “BT ON”

(page25).

Connection is not possible.

• The BLUETOOTH device you

attempted to connect does not

support the A2DP profile, and

cannot be connected with the

system.

• Enable the BLUETOOTH function of

the BLUETOOTH device.

• Establish a connection from the

BLUETOOTH device.

• The pairing registration information

has been erased. Perform the

pairing operation again.

• Erase the pairing registration

information of the BLUETOOTH

device by resetting the system to

factory default settings (page37)

and perform the pairing operation

again (page22).

The sound skips or fluctuates, or the

connection is lost.

• The system and the BLUETOOTH

device are too far apart.

• If there are obstacles between the

system and your BLUETOOTH device,

remove or avoid the obstacles.

• If there is equipment that generates

electromagnetic radiation, such as

a wireless LAN, other BLUETOOTH

device, or a microwave oven nearby,

move them away.

The sound of your BLUETOOTH device

cannot be heard on this system.

• Increase the volume on your

BLUETOOTH device first, then adjust

the volume using VOL +/–.

There is severe hum, noise, or

distorted sound.

• If there are obstacles between the

system and your BLUETOOTH device,

remove or avoid the obstacles.

• If there is equipment that generates

electromagnetic radiation, such as

a wireless LAN, other BLUETOOTH

device, or a microwave oven nearby,

move them away.

• Turn down the volume of the

connected BLUETOOTH device.

Party Chain

Party Chain function cannot be

activated.

• Check the connections (page28).

• Make sure the audio cords are

connected correctly.

• Select the function other than the

Audio In function (page30).

Party Chain function does not work

properly.

• Turn off the system. Then, turn it

back on again to activate the Party

Chain function.

Resetting the system

If the system still does not operate

properly, reset the system to factory

default settings.

1

Disconnect and reconnect the

AC power cord, and then turn

on the system.

2

Hold down  and – on the

unit until “RESET” appears on

the display.

All user-configured settings, such

as preset radio stations and the

pairing registration information, are

reset to factory default settings.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 122 123

Commentaires sur ces manuels

Pas de commentaire