Sony XSP-N1BT Manuel d'utilisateur Page 24
- Page / 56
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
24GB
G:\DATA\4533738311\01GB-XSPN1BTE\040CD.fm masterpage: Left
XSP-N1BT
4-533-738-31(1)
The sound skips.
Defective or dirty disc.
USB playback
You cannot play back items via a USB hub.
This unit cannot recognize USB devices via a USB
hub.
A USB device takes longer to play back.
The USB device contains files with a complicated
tree structure.
The sound is intermittent.
The sound may be intermittent at a high-bit-rate
of more than 320 kbps.
Application name is mismatched with the actual
application in App Remote.
Launch the application again from the “App
Remote” application.
NFC function
One touch connection (NFC) is not possible.
If the smartphone does not respond to the
touching.
Check that the NFC function of the smartphone
is turned on.
Move the N-Mark part of the smartphone
closer to the N-Mark part on this unit.
If the smartphone is in a case, remove it.
NFC receiving sensitivity depends on the device.
If One touch connection with the smartphone
fails several times, make BLUETOOTH connection
manually.
BLUETOOTH function
The connecting device cannot detect this unit.
Before the pairing is made, set this unit to pairing
standby mode.
While connected to a BLUETOOTH device, this
unit cannot be detected from another device.
Disconnect the current connection and search
for this unit from another device.
When the device pairing is made, set the
BLUETOOTH signal output to on (page 8).
Connection is not possible.
The connection is controlled from one side (this
unit or BLUETOOTH device), but not both.
Connect to this unit from a BLUETOOTH device
or vice versa.
The name of the detected device does not
appear.
Depending on the status of the other device, it
may not be possible to obtain the name.
No ringtone.
Adjust the volume by pressing VOL +/- while
receiving a call.
Depending on the connecting device, the
ringtone may not be sent properly.
Set [RINGTONE] to [1] (page 18).
The front speakers are not connected to the unit.
Connect the front speakers to the unit. The
ringtone is output only from the front speakers.
The talker’s voice cannot be heard.
The front speakers are not connected to the unit.
Connect the front speakers to the unit. The
talker’s voice is output only from the front
speakers.
A call partner says that the volume is too low or
high.
Adjust the volume accordingly using mic gain
adjustment (page 14).
Echo or noise occurs in phone call conversations.
Lower the volume.
Set EC/NC Mode to [EC/NC-1] or [EC/NC-2]
(page 14).
If the ambient noise other than the phone call
sound is loud, try reducing this noise.
E.g.: If a window is open and road noise, etc., is
loud, shut the window. If an air conditioner is
loud, lower the air conditioner.
The phone is not connected.
When BLUETOOTH audio is played, the phone is
not connected even if you press CALL.
Connect from the phone.
The phone sound quality is poor.
Phone sound quality depends on reception
conditions of cellular phone.
Move your car to a place where you can
enhance the cellular phone’s signal if the
reception is poor.
The volume of the connected audio device is low
(high).
Volume level will differ depending on the audio
device.
Adjust the volume of the connected audio
device or this unit.
ML.book Page 24 Tuesday, February 4, 2014 4:40 PM
- Smartphone Cradle 1
- Receiver 1
- Note on the lithium battery 2
- About this manual 2
- Notes on BLUETOOTH function 3
- Table of Contents 4
- Guide to Parts and Controls 5
- Switching the FM/AM Tuning 7
- Setting the Clock 7
- Connecting an iPod/USB Device 7
- Preparing a BLUETOOTH Device 7
- To cancel pairing 8
- To install the microphone 8
- Placing a Smartphone on the 9
- Listening to the Radio 10
- Using Radio Data System (RDS) 11
- Playing a Disc 11
- Playing an iPod/USB Device 11
- Playing a BLUETOOTH Device 12
- Searching and Playing Tracks 12
- Making a Call 13
- Receiving a Call 13
- Available Operations during 14
- App Remote with iPhone/ 14
- Android Phone 14
- If the device number appears 15
- To terminate connection 15
- To activate voice recognition 15
- Canceling the DEMO Mode 16
- Basic Setting Operation 16
- GENERAL Setup 16
- SOUND Setup 16
- DISPLAY Setup 18
- BT (BLUETOOTH) Setup 18
- APP REM (App Remote) Setup 18
- Precautions 19
- About BLUETOOTH function 20
- Maintenance 21
- Specifications 21
- Copyrights 22
- Troubleshooting 23
- USB playback 24
- NFC function 24
- BLUETOOTH function 24
- Error displays/Messages 25
- For BLUETOOTH function: 26
- For App Remote operation: 26
- XSP-N1BT 27
- 4-533-738-31(1) 27
- Nota sobre la pila de litio 28
- Sobre este manual 28
- Tabla de contenidos 30
- Unidad principal 31
- Control remoto RM-X311 31
- Procedimientos iniciales 33
- Conexión con un dispositivo 34
- BLUETOOTH emparejado 34
- Colocar un smartphone en la 35
- Colocación del smartphone 36
- Para retirar el smartphone 36
- Escuchar la radio 37
- Reproducción de un disco 38
- BLUETOOTH 38
- Búsqueda y reproducción de 39
- Rechazo de llamadas 40
- Realización de llamadas 40
- Llamada por etiquetas de voz 41
- App Remote con iPhone/ 42
- Cancelación del modo DEMO 44
- Operación básica de ajustes 44
- Configuración GENERAL 44
- Configuración SOUND 44
- Configuración DISPLAY 46
- Configuración BT (BLUETOOTH) 46
- Configuración APP REM (App 46
- Precauciones 47
- Acerca de iPod 48
- Mantenimiento 49
- Especificaciones 50
- Solución de problemas 51
- Recepción de radio 52
- Reproducción de CD 52
- Reproducción USB 52
- Función NFC 52
- Función BLUETOOTH 53
- Support site 56
Produits connexes et manuels pour Récepteurs de médias en voiture Sony XSP-N1BT
(40 pages)
(78 pages)© 2020, manymanuals.fr. Tous droits réservés | 2.916 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels