Sony HT-NT5 Manuel d'utilisateur télécharger pdf (Page 65)

65

GB

Troubleshooting

 If there is an obstacle between the

unit and the subwoofer, move or

remove it.

 Locate the unit and the subwoofer as

close as possible.

 Switch the wireless LAN frequency of

any nearby Wi-Fi router or PC to

5GHz range.

 Switch the network connection of the

TV or Blu-ray Disc Player from

wireless to wired.

No sound or only very low-level

sound is heard from the wireless

speaker.

 Depending on the input signal, a

surround effect with presence may

not be obtained. Depending on the

program or disc, audio signals for the

surround channels are output at a

very low level.

 When you play content compatible

with copyright protection technology

(HDCP, SCMS-T, etc.), it may not be

output from the system.

 Check the surround speakers

connection on [Wireless Surround

Settings] - [Surround Speaker

Connection Check].

 Adjust the volume level of the

surround speakers on [Wireless

Surround Settings] - [Surround

Speaker Setting].

The sound is delayed behind the

picture.

 When using the wireless surround

function, the sound may be delayed.

The system cannot connect to the

network.

 The wireless LAN function is not

available when using the wireless

surround function. Connect to the

network via wired LAN.

The wireless speakers cannot be

connected to the system.

 Update the software version of the

system and wireless speakers to the

latest version.

The remote control of this system

does not function.

 Point the remote control at the

remote control sensor on the unit

(page 7).

 Remove any obstacles in the path

between the remote control and the

system.

 Replace both batteries in the remote

control with new ones, if they are

weak.

 Make sure you are pressing the

correct button on the remote control.

TV remote control does not work.

 This problem might be solved by

enabling the IR repeater function

(page 54).

The Control for HDMI function does

not work properly.

 Check the connection with the

system (refer to the supplied Startup

Guide).

 Enable the Control for HDMI function

on the TV. For details, refer to the

operating instructions of your TV.

 Wait a while, and then try again. If

you unplug the system, it will take a

while before operations can be made.

Wait for 15 seconds or longer, and

then try again.

 Make sure the devices connected to

the system support the Control for

HDMI function.

 Enable the Control for HDMI function

on the devices connected to the

Wireless Surround

Remote Control

Others

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 83 84

Commentaires sur ces manuels

Pas de commentaire