Sony Cyber-shot DSC-W1 Manuel d'utilisateur Page 16

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 128
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 15
16
Using the AC adaptor
, Open the DC IN jack cover and
connect the AC Adaptor
AC-LS5 (not supplied) to the
DC IN jack of your camera.
Connect the DC plug with the v mark
facing the front of the camera.
Be sure to use the AC-LS5 AC Adaptor.
Other AC adaptors cannot be used with
this camera.
Connect the AC Adaptor to an easily accessible
wall outlet (wall socket) close by. If any trouble
occurs while using the adaptor, immediately
shut off the power by disconnecting the plug
from the wall outlet (wall socket).
, Connect the power cord (mains
lead) to the AC Adaptor and
then to a wall outlet (wall
socket).
After using the AC Adaptor, disconnect it both
from the DC IN jack of the camera and from a
wall outlet (wall socket).
The set is not disconnected from the AC power
source (mains) as long as it is connected to the
wall outlet (wall socket) even if the set itself has
been turned off.
1
DC IN jack cover
AC Adaptor
(not supplied)
DC plug
2
2 To wall outlet
(wall socket)
Power cord
(mains lead)
1
Using your camera
abroad
Power sources
You can use your camera in any country or
region with the battery charger (supplied) or
the AC Adaptor AC-LS5 (not supplied)
within 100 V to 240 V AC, 50/60 Hz. Use a
commercially available AC plug adaptor
[a], if necessary, depending on the design of
the wall outlet (wall socket) [b].
Do not use an electronic transformer (travel
converter), as this may cause a malfunction.
BC-CS2A/CS2B
Vue de la page 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 127 128

Commentaires sur ces manuels

Pas de commentaire