Sony DCR-PC105 Instructions d'exploitation Page 102

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 240
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 101
102
You can record additional audio to the original sound on a tape by connecting audio
equipment or a microphone. If you connect suitable audio equipment, you can add
sound to your tape already recorded in the 12-bit mode by specifying starting and
ending points. The original sound will not be erased.
You cannot perform audio dubbing:
On a tape recorded in the 16-bit mode
On a tape recorded in the LP mode
When an i.LINK cable is connected
On blank portions of a tape
When the write-protect tab of a cassette is set to SAVE
Preparing for audio dubbing
You can record additional audio in the following ways:
Dubbing with the built-in microphone
Connecting the microphone (optional) to the MIC jack
Connecting the microphone (optional) to the intelligent accessory shoe
Connecting the A/V connecting cable to the AUDIO/VIDEO jack
The audio input to be recorded will take precedence over others in the following order:
MIC jack
Intelligent accessory shoe
AUDIO/VIDEO jack
Built-in microphone
Dubbing with the built-in microphone
No connection is necessary. (If no external microphone is connected, audio recording
will be performed automatically by the built-in microphone.)
Connecting the microphone (optional) to the MIC jack
You can check the recorded picture and sound by connecting the AUDIO/VIDEO jack
to a TV.
The recorded sound is not output from the speaker. Check the sound by using the
headphones or TV.
Audio dubbing
MIC (PLUG IN
POWER)
Microphone (optional)
: Signal flow
Vue de la page 101
1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 239 240

Commentaires sur ces manuels

Pas de commentaire