Sony MDS-JE500 Manuel d'utilisateur télécharger pdf (Page 27)

Editing Recorded MDs

6 Repeat Steps 3 to 5 until you have entered the

entire title.

If you entered the wrong character

Press 0 or ) until the character to be corrected starts

flashing, and repeat Steps 3 to 5 to enter the correct

character.

To erase a character

Press 0 or ) until the character to be erased starts

flashing, then press EDIT/NO.

To enter a space

Press AMS or ) while the cursor is flashing.

7 Press YES.

This completes the labeling procedure and the

title appears on the left side of the display.

To cancel labeling

Press p.

Note

You cannot label a track or an MD while you are recording

over an existing track.

3 Press DISPLAY/CHAR to select the character

type as follows:

4 Turn AMS to select the character.

The selected character flashes.

Letters, numbers, and symbols appear in

sequential order as you turn AMS.

You can use the following symbols in titles:

! ” # $ % & ’ ( ) * + , – . / : ; < = > ? @ _ `

You can press DISPLAY/CHAR to change the

character type at any time during Step 4 (see

Step 3).

5 Press AMS to enter the selected character.

The cursor shifts rightward and waits for the

input of the next character.

To select

Press DISPLAY/CHAR repeatedly

until

Uppercase letters “A” appears in the display

Lowercase letters “a” appears in the display

Numbers “0” appears in the display

(Continued)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Pas de commentaire

Sony MDS-JE500 Manuel d'utilisateur Page 27