Sony MHC-EX600 Instructions d'exploitation télécharger pdf (Page 26)

26

GB

• The number of files has exceeded

5,000.

• Files that are encrypted or protected by

passwords, etc. cannot be played back.

* This system supports FAT16 and FAT32, but

some USB storage devices may not support

all of these FAT. For details, refer to the

operation manual of each USB storage

device or contact the manufacturer.

Tuner

Severe hum or noise, or stations

cannot be received. (“TUNED” or

“ST” flashes on the display.)

• Connect the antenna properly.

• Change antenna location and its

orientation to obtain good reception.

• Keep the antennas away from the

speaker cords, the power cord and the

USB cable to avoid picking up noise.

• Consult your nearest Sony dealer if the

supplied AM antenna has come off the

plastic stand.

• Turn off nearby electrical equipment.

To change the AM tuning interval

(Except for European, Russian and Saudi

Arabian models)

The AM tuning interval is preset to 9 kHz

or 10 kHz by factory default.

1 Tune to any AM station, and then

turn off the system.

2 Press DISPLAY to display the

clock.

3 While holding down TUNING + on

the unit, press ?/1 on the unit.

All the AM preset stations are erased.

To reset the interval to the factory

preset, repeat the procedure.

To improve disc loading

performance

Turn on the CD player/USB device power

using the CD/USB power management

function. By default, the CD player/USB

device power is turned off.

1 Press FUNCTION repeatedly to

select the CD function.

2 Press ?/1 to turn off the system.

3 After “STANDBY” stops flashing,

press DISPLAY to display the clock

and then press ?/1 on the unit while

holding down x on the unit.

“CD/USB PWR ON” appears. Turning

the CD player/USB device power on,

decreases disc access time and

improves loading performance.

If there is poor tuner reception when

the CD player/USB device power is

turned on, return the setting to default.

To turn off the CD player/USB device

power, repeat the procedure until “CD/

USB PWR OFF” appears. Note that

when turning off the CD player/USB

device power in the tuner function,

power is not supplied to the USB

device, and the device is therefore not

recognized and not charged by the

system, even if connected.

To reset the system to factory

settings

If the system still does not operate

properly, reset the system to factory

settings. You cannot reset the system to

factory settings in Power Saving Mode.

Use buttons on the unit to reset the unit to

its factory default settings.

1 Disconnect and reconnect the

power cord, and then turn on the

system.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire