Sony PCG-K33 Manuel d'utilisateur télécharger pdf (Page 139)

Removing and Installing Memory Modules

Make sure you read the safety information in Precautions and Procedures before you remove or install a memory module.

When installing a memory module, do not open the module package until you are ready to install it. The package protects

the module from Electrostatic discharge (ESD).

For memory upgrades and information about which memory modules to use, refer to your VAIO

Computer Specifications

available on the Welcome page.

To remove a memory module

Turn off the computer and all attached devices.

Disconnect the power cord, all cables, and remove the battery if it is installed. SeeTo remove a battery.

Wait for the computer to cool down.

The interior of the computer becomes extremely hot during operation. Wait at least one hour for the computer to

cool down before you remove the screws.

Turn the computer over and use an appropriate screwdriver to loosen and remove the screw(s) on the memory

bay.

To avoid damaging the computer, do not remove or loosen any other screws.

Removing the Bottom Screw(s)

Remove the cover.

Touch a metal object (such as the connector panel on the back of your computer) to discharge static electricity.

Avoid touching any part of the motherboard or other components inside the computer.

Remove the memory module by pulling out the tabs (see arrows No. 1), and pulling out the module in the

direction of arrow No. 2. See To install a memory module for more information.

Removing a Mem ory Module

To install a memory module

Remove the new memory module from its packaging, and install the memory module by sliding it into the open

Page 139

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 150 151

Pas de commentaire

Sony PCG-K33 Manuel d'utilisateur Page 139