Sony SDM-S95ER Manuel d'utilisateur télécharger pdf (Page 9)

Setup 4:Connect the power cord

If you use the fixed stand, draw the power cord through the stand

hole first and then connect them to the display. For more details

see “Setup 5: Secure the cords.”

1 Connect the supplied power cord securely to the

display’s AC IN connector.

2 Connect the other end securely to a power outlet.

Setup 5:Secure the cords

x Fixed Stand

Be sure that the cords and cables have been drawn into the stand

hole as illustrated.

x Height adjustable stand

Draw the cords and cables through the cable holder as illustrated.

Note

When bounding the cords and cables, be sure to loosen them a little. If

they get pulled hard they may come off from the connectors or plugs as

you adjust the screen angle. If you stretch the cords and cables too hard

they may get damaged.

Setup 6:Turn on the display and

computer

1 Press the 1 (power) switch located on the front

right of the display.

The 1 (power) indicator lights up in green.

2 Turn on the computer.

If no picture appears on your screen

• Check that the power cord and the video signal cables are

properly connected.

• If “NO INPUT SIGNAL” appears on the screen:

– The computer is in the power saving mode. Try pressing any

key on the keyboard or moving the mouse.

– Check that the input signal setting is correct by pressing the

OK button (page 11).

• If “CABLE DISCONNECTED” appears on the screen:

– Check that the video signal cables are properly connected.

– Check that the input signal setting is correct by pressing the

OK button (page 11).

to AC IN

to a power outlet

power cord (supplied)

lights in green

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 96 97

Pas de commentaire

Sony SDM-S95ER Manuel d'utilisateur Page 9