Sony MHC-V21D Manuel d'utilisateur télécharger pdf (Page 64)

64

GB

MHC-V21D.GB.4-734-744-13(1)

•—

The internal memory is

fragmented.

“NO FILE” appears on the display.

••

The system has entered the

software update mode, and

all buttons (except ) are

deactivated. Press  on the unit to

cancel the software update.

“OVER CURRENT” appears on the

display.

••

A problem has been detected

with the level of electrical current

from the

(USB) port. Turn off

the system and remove the USB

device from the port. Make sure

there is no problem with the USB

device. If this display pattern

persists, contact your nearest Sony

dealer.

Erroneous display.

••

The data stored in the USB

device may have been corrupted,

perform the transfer again.

••

The character codes that can be

displayed by this system are as

follows:

•—

Upper cases (A to Z)

•—

Numbers (0 to 9)

•—

Symbols (< > * +, [ ] \ _)

Other characters appear as “_”.

The USB device is not recognized.

••

Turn off the system and reconnect

the USB device, then turn on the

system.

••

Check the information on the

website about compatible USB

devices (page 11).

••

The USB device is not working

properly. Refer to the operating

instructions of the USB device on

how to deal with this problem.

Playback does not start.

••

Turn off the system and reconnect

the USB device, then turn on the

system.

••

Check the information on the

website about compatible USB

devices (page 11).

Playback does not start from the

first file.

••

Set the play mode to Normal Play

(page 26).

Files cannot be played back.

••

Make sure you have selected

the correct Media Mode before

playback.

••

USB devices formatted with file

systems other than FAT16 or FAT32

are unsupported.*

••

If you use a partitioned USB

device, only files on the first

partition can be played back.

* This system supports FAT16 and FAT32,

but some USB devices may not support

all of these FAT. For details, refer to the

operating instructions of each USB

device or contact the manufacturer.

Picture

There is no picture.

••

Check that the system is

connected securely.

••

If the video cable or HDMI cable

is damaged, replace it with a new

one.

••

Make sure you connect the unit to

the HDMI input jack or the video

input jack of your TV (page19).

••

Make sure you turn on the TV and

operate the TV correctly.

••

Make sure you select the input

according to the connection on

the TV so that you can view the

pictures from the system.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 79 80

Commentaires sur ces manuels

Pas de commentaire