Sony SAT-A4 Manuel d'utilisateur télécharger pdf (Page 73)

To Determine the Current

Security Code for the

Remote Control

(SAT-A4 Only)

Step 2: Set the Remote Control's RF Security Code

1 Press the CODE SET button on the remote control.

2 Using the number buttons on the remote control, enter the three-

digit security code you selected for the Digital Satellite Receiver in

step 2 on page 72.

3 Press the ENTER button on the remote control.

The RF security code is now changed for both the Digital Satellite

Receiver and remote control.

You can determine the current RF security code for the remote control

using the IDENTIFY button in the Set Up Remote screen.

1 Bring up the Set Up Remote screen, as described on page 71.

2 Select IDENTIFY.

SET UP REMOTE

REMOTE SIGNAL

IR ONLY

CANCEL

RF SECURITY CODE000

IDENTIFY

1 HELP

REMOTE CODES

Press the joystick within 5 seconds.

3 When the message "Press the joystick within 5 seconds" appears,

press the joystick before the 5 seconds expire.

The current RF security code for the remote control appears.

SET UP REMOTE

REMOTE SIGNAL

IR ONLY

RE SECURITY CODE 000

CANCEL I

IDENTIFY

HELP

REMOTE CODES

Your remote is currently set at 000.

Note

If the message, "Security code could not be identified" appears, check to make

sure that RF is enabled and that the RF antenna is connected properly. See

"Selecting IR/RF Transmission (SAT-A4 Only)" on page 71.

4 Select OK to return to the Setup Menu.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 95 96

Pas de commentaire

Sony SAT-A4 Manuel d'utilisateur Page 73