Sony DAR-RD100 Manuel d'utilisateur Page 105

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 120
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 104
105
Additional Information
, Insert a recordable disc into the recorder.
The recording mode indication is incorrect.
, When the recording or dubbing is less than three
minutes, the recording mode indication may be
displayed incorrectly. The actual recording itself
is correctly made in the selected recording mode.
Remote control
The remote does not function.
, Batteries are weak.
, The remote is too far from the recorder or the
centre unit.
, The remotes manufacturer code returned to the
default setting when you replaced the batteries.
Reset the code (page 98).
, Turn on the recorder and/or the centre unit.
, Point the remote at the recorder when operating
the recorder, and at the the centre unit when
operating the speaker system.
, Different command modes are set for the
recorder and remote. Set the same command
mode (page 99).
, Set the AMP/DVD switch to the other position,
and try again (page 109).
Other Sony equipment responds to the remote.
, The same command mode is set for both the
equipment and recorder. Set a different
command mode for the recorder (page 99).
Others
Radio stations cannot be tuned in.
, Check that the FM/AM aerial is connected
securely. Adjust the aerial or connect an external
aerial, if necessary.
, The reception is poor. Try manual tuning
(page 96).
, No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the stations
(page 96).
, Press FM DISPLAY so that the frequency
appears in the centre unit display.
, Keep the AM aerial away from the system and
other equipment (recorder, subwoofer, TV, etc.).
The recorder does not operate properly.
, Restart the recorder. Press down DVD "/1 on
the recorder for more than ten seconds to turn off
the recorder. If a disc is still in the recorder, press
Z (open/close) and remove the disc.
, When static electricity, etc., causes the recorder
to operate abnormally, turn off the recorder and
wait until the clock appears in the front panel
display. Then, unplug the recorder and after
leaving it off for a while, plug it in again.
The disc tray does not open after you press Z
(open/close).
, It may take a few seconds for the disc tray to
open after you have recorded or edited a disc.
This is because the recorder is adding disc data to
the disc.
Mechanical sound is heard when the recorder
is off.
, While the recorder is adjusting the clock for the
Auto Clock Set function or scanning the
channels for the PDC/VPS function, operational
noises (such as the internal fan) may be heard,
even when the power is off. This is not a
malfunction.
Mechanical sound is heard from the subwoofer
or the recorder when no disc is played.
, The recorder and the subwoofer have ventilation
fans, which operate when the power is on.
Mechanical sound may also be heard when the
disc spins. These are operational sounds and are
not malfunctions.
The speaker does not work normally.
, Disconnect the mains lead of the subwoofer from
the mains. Wait about two minutes until the
"/1
indicator on the centre unit turns off, and then
connect the mains lead.
Vue de la page 104
1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 119 120

Commentaires sur ces manuels

Pas de commentaire