Sony TA-VE800G Manuel d'utilisateur Page 21
- Page / 181
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
21
GB
Preparing and Using the Remote
Keep the remote pointed horizontally at the IR
sensor until the code is programmed.
If you tilt or move the remote during the
programming procedure, the IR code may not be
programmed correctly.
Repeat this procedure for the remaining buttons
After you’ve programmed all the IR codes, the IR CODE
SETTING menu reappears.
To reprogramme a specific IR code
Click the button where the IR code was programmed, then
click START.
To Erase IR codes
Click CODE CLEAR.
• To erase one specific IR code
1 Click SINGLE IR CODE CLEAR.
2 Click the button you want to clear.
“Are you sure?” appears for confirmation.
3 Click YES to erase the code.
“CODE CLEAR!” appears in the display.
To stop before erasing a code, click NO.
To erase another code repeat steps 2 and 3.
• To erase all the user IR codes
1 Click USER IR CODE CLEAR.
“Are you sure?” appears for confirmation.
2 Click YES to erase the codes.
“CODE CLEAR!” appears in the display.
To stop before erasing the codes, click NO.
• To all the IR codes
1 Click ALL IR CODE CLEAR.
“Are you sure?” appears for confirmation.
2 Click YES to erase the codes.
“CODE CLEAR!” appears in the display.
To stop before erasing all the codes, click NO.
Notes
• Even if the amplifier’s mains lead has been disconnected
from the mains, programmed IR codes will stay in the
memory for approximately two weeks. If they disappear,
“ALL CLEAR” will appear on the TV screen when you
turn on the unit again.
• The power switch on some air conditioners use two
independent IR codes, even when there is only one switch.
If you cannot turn the air conditioner off with the IR code
programmed for the on/off switch, repeat the procedure
and programme the on and off IR codes separately.
• The operation of some air conditioner remote commanders
require two–way signal exchange with the air conditioner
itself. Though it is possible to programme the IR codes of
such remote commanders in the unit, their use may not
result in normal air conditioner operation.
• The unit may not be able to register IR codes with special
waveforms produced on some remote commanders.
- Integrated AV 1
- Amplifier 1
- Precautions 2
- About This Manual 3
- Features 4
- Unpacking 7
- Hookup Overview 7
- IR Repeater Hookups 8
- Audio Component Hookups 8
- Speaker System Hookups 9
- TV/VCR Hookups 10
- AC Hookups 11
- Before You Use Your Amplifier 11
- Inserting Batteries Into the 12
- How to Use the Remote 12
- Be sure your hand 13
- Registering a TV 14
- Registering Audio/Video 16
- Equipment 16
- (continued) 17
- Programming Other Infrared 20
- (IR) Codes (USER IR setting) 20
- Selecting a Component 22
- Recording 24
- Using the Sleep Timer 25
- Introduction 26
- Using Pre-programmed Sound 26
- Using Surround Sound 27
- Getting the Most Out of Dolby 28
- Pro Logic Surround Sound 28
- Customizing the Sound Fields 29
- SUR EDIT 30
- Using the INDEX functions 31
- Operating a CD Changer 33
- Operating Several Components 35
- (macro play) 35
- Remote Operation of Audio 36
- Sources Without the TV 36
- (illuminated control flasher) 36
- Playing Sources Automatically 37
- (auto play) 37
- Starting a Source 37
- Automatically at Power On 37
- (auto start) 37
- Selecting the Display 38
- Parameters 38
- Adjusting the Position of the 39
- On-Screen Display 39
- Front Panel Descriptions 40
- Rear Panel Descriptions 41
- Troubleshooting 42
- Additional Information 43
- Specifications 44
- Glossary 45
- Test tone 46
- (PHANTOM mode) 46
- AVERTISSEMENT 47
- Précautions 47
- Au sujet de ce 48
- Caractéristiques 49
- FUNCTION 51
- Déballage 52
- Description des raccordements 52
- Raccordement du répéteur IR 53
- Raccordement d’appareils 53
- Raccordement d’enceintes 54
- Raccordement d’un téléviseur/ 55
- Raccordement au courant 56
- 3 Fermez le couvercle 57
- Autonomie des piles 57
- Rayons infrarouges (IR) 58
- Veillez à ne pas 58
- Enregistrement d’appareils 61
- (voir page suivante) 62
- Remarques 64
- Programmation d’autres codes 65
- SETTING) 65
- Sélection d’un appareil 67
- Enregistrement 69
- Utilisation du temporisateur 70
- Utilisation du son surround 72
- Optimisation du son surround 73
- Dolby Pro Logic 73
- Personnalisation d’un champ 74
- Utilisation des fonctions 76
- Fonctionnement d’un changeur 78
- Utilisation séquentielle de 80
- Commande à distance de 81
- Lecture automatique d’une 82
- Démarrage automatique d’une 82
- (AUTO START) 82
- Sélection des paramètres 83
- Réglage de la position de 84
- Description du panneau avant 85
- Autres informations 86
- Guide de dépannage 87
- Spécifications 89
- Glossaire 90
- Precauciones 92
- ADVERTENCIA 92
- Descripción de este 93
- Desembalaje 97
- Descripción general de las 97
- Conexión del repetidor de IR 98
- Conexión de componentes de 98
- Conexión de sistemas de 99
- Conexión de un televisor/ 100
- Conexión de CA 101
- Antes de utilizar su 101
- Inserción de las pilas en el 102
- Cerciórese de que 103
- Rayos infrarrojos 103
- Registro de un televisor 104
- Registro de equipos de audio/ 106
- (Continúa) 107
- Programación de otros códigos 110
- (Ajuste de IR de usuario) 110
- Selección de un componente 112
- Grabación 114
- Utilización del 115
- Introducción 116
- Campos acústicos 117
- GENRE MODE para 117
- Disfrute al máximo de sonido 118
- Dolby Pro Logic Surround 118
- Personalización de los campos 119
- Operación de un cambiador de 123
- Operación secuencial 125
- Operación remota de fuentes 126
- (destellador de control 126
- Ajuste de la sensibilidad del 128
- Ajuste de la posición de la 129
- Descripción del panel frontal 130
- Información adicional 131
- Solución de problemas 132
- Especificaciones 134
- Glosario 135
- Índice alfabético 136
- ADVERTÊNCIA 137
- Precauções 137
- Acerca deste manual 138
- Características 139
- Introdução 140
- Funcionamento do amplificador 141
- Descrição das Ligações 142
- Desempacotamento 142
- Ligações do repetidor IR 143
- Ligações de Componentes de 143
- Ligações do Sistema de 144
- Altifalantes 144
- Ligações do Televisor/ 145
- Videogravador 145
- Ligações à CA 146
- Antes de Utilizar o 146
- Amplificador 146
- Inserção de pilhas no 147
- Como utilizar o telecomando 147
- Raios IR 148
- Registo de um televisor 149
- Registo de equipamentos de 151
- (continua...) 152
- Programação de outros 155
- (ajuste USER IR) 155
- Selecção de um Componente 157
- Gravação 159
- Utilização do temporizador 160
- Utilização dos campos 161
- GÉNERO MODO Para 162
- Obtenção do Máximo em 163
- Logic Surround 163
- Personalização dos campos 164
- Utilização das funções INDEX 166
- USERLIST SUB 167
- Operação de um permutador 168
- Operação automática de 170
- Operação por telecomando de 171
- Reprodução automática de 172
- Activação automática de uma 172
- Ajuste da sensibilidade do 173
- Selecção dos parâmetros do 173
- Ajuste da posição do 174
- Descrição do Painel Frontal 175
- Descrição do Painel Posterior 176
- Verificação de Problemas 177
- Informações Adicionais 178
- Especificações 179
- Glossário 180
- Índice Remissivo 181
Produits connexes et manuels pour Récepteurs et amplificateurs Sony TA-VE800G
(32 pages)
(2 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.122 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels