Sony SDM-P82 Instructions d'exploitation télécharger pdf (Page 10)

G:\4090729111\0490729111SDMP82UC\02US-SDMP82UC\01US02BAS-UC.fm

masterpage:Left

SDM-P82

4-090-729-11(1)

If no picture appears on your screen

• Check that the power cord and the video signal cable are

properly connected.

• If NO INPUT SIGNAL appears on the screen:

– The computer is in the power saving mode. Try pressing any

key on the keyboard or moving the mouse.

– Check that the input signal setting is correct by pressing the

INPUT button repeatedly (page 11).

• If CABLE DISCONNECTED appears on the screen:

– Check that the video signal cable is properly connected.

– Check that the input signal setting is correct by pressing the

INPUT button repeatedly (page 11).

• If OUT OF SCAN RANGE appears on the screen, reconnect

the old monitor. Then adjust the computer’sgraphicsboardin

the following ranges.

For more information about on-screen messages, see “Trouble

symptoms and remedies” on page 19.

No need for specific drivers

The monitor complies with the “DDC” Plug & Play standard and

automatically detects all the monitor’s information. No specific driver

needs to be installed to the computer.

The first time you turn on your computer after connecting the monitor, the

setup Wizard may appear on the screen. In this case, follow the on-screen

instructions. The Plug & Play monitor is automatically selected so that

you can use this monitor.

The vertical frequency turns to 60 Hz.

Since flickers are unobtrusive on the monitor, you can use it as it is. You

do not need to set the vertical frequency to any particular high value.

Setup 6:Adjusting the tilt

This monitor can be adjusted within the angles shown below.

To use the monitor comfortably

Adjust the viewing angle of your monitor according to the height

of your desk and chair, and so that light is not reflected from the

screen to your eyes.

Note

When adjusting the screen tilt, proceed slowly and carefully, being sure

not to hit the monitor against the desk or the base of the display stand.

1 Grasp the lower middle part of the LCD panel while

holding the display stand, then, tilt the LCD panel

adequately backward.

2 Grasp the lower sides of the LCD panel, then adjust

screen tilt.

Horizontal frequency 28 – 92 kHz

Vertical frequency 56 – 85 Hz

Resolution 1280 × 1024 or less

20°

5°

01US01COV-UC.book Page 10 Friday, May 17, 2002 3:51 PM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Commentaires sur ces manuels

Pas de commentaire

Sony SDM-P82 Instructions d'exploitation Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Téléviseurs et moniteurs Sony SDM-P82