Sony PCWA-A100 Manuel d'utilisateur télécharger pdf (Page 18)

Attaching the unit stand

The unit stand allows you to place your Access Point in an upright

position.

When the unit stand is attached, wire cables are routed through the

recessed groove.

Before attaching the unit stand

Make sure to write down the six-digit Access Point ID on the label

attached on the bottom surface of the Access Point.

Note

Category 5 Ethernet cable is recommended or you may not be able to attach the

unit stand to the Access Point.

Attach the unit stand to the Access Point as shown in the figure below.

Engage Joint A with Joint B and slide the Access Point in the direction

indicated by the arrow until it clicks.

z Tip

The unit stand may be attached in either direction.

To remove the unit stand

Slide the Access Point and unit stand in opposite directions to detach.

Joint A

Joint B

Groove

Access Point ID

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Pas de commentaire

Sony PCWA-A100 Manuel d'utilisateur Page 18