Sony PCWA-A100 Manuel d'utilisateur télécharger pdf (Page 19)

Setting Up

After you connect and install your Access Point, see the enclosed

manual, Wireless LAN PC Card Operating Instructions. This manual

provides instructions on how to insert the card in the computer, install

and set up its software, and install the software needed to set up the

Access Point.

Factory-Set configuration of the Access Point

The Access Point is configured at shipment as follows:

Connection mode

Cable Modem/xDSL mode

IP settings

IP address in the WAN: automatically obtained. (The Access Point

serves as a DHCP client.)

IP address in the wireless LAN: 10.0.1.1

The Access Point serves as the DHCP server for client computers on

the LAN.

The number of IP addresses in the pool is set to 16.

The IP addresses to be assigned are 10.0.1.2 through 10.0.1.17.

The above configuration may be modified using the Custom Access

Point Setup Utility that comes with the Wireless LAN PC Card. For

further instructions, refer to the Custom Access Point Setup Utility

Help.

Ethernet MAC address

The Ethernet MAC Address can be verified by following the steps

below:

1 Right-click the Wireless Palette icon on the Microsoft

Windows

task tray.

2 Click Version in the pop-up menu.

3 Verify the number shown for Wireless Access Point Ethernet

Address.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Pas de commentaire

Sony PCWA-A100 Manuel d'utilisateur Page 19