Sony SAT-A4 Manuel d'utilisateur télécharger pdf (Page 18)

Connecting the IR Blaster

SAT-A4 receiver is pictured, hut

connections are identical for SAT-B3.

The IR Blaster works with the Digital Satellite Receiver's Timer

function to automatically start and stop the recording function of your

"VCR.

1 Connect the IR Blaster to the Digital Satellite Receiver's VCR

CONTROL jack. Then place the IR Blaster below and in front of the

VCR, about ^

" to 1". For best results, place the IR Blaster directly

below the VCR's IR receiving area.

Digital Satellite Receiver

If the IR Blaster doesn't seem to be

working correctly, first check that the IR

Blaster is positioned directly below the

VCR's [R receiving area and that the

VCR's line input is set to the Digital

Satellite Receiver. If it's still not working,

try this procedure again using the other

codes listed for your VCR on page 86.

Set the manufacturer, and code type of your VCR using the VCR

RECORDING Screen on page 66. This must be done for the IR

Blaster to function properly.

To use the IR Blaster: 1) Set the Timer (page 35), 2) Turn

on the VCR and set the VCR's line input to the Digital Satellite

Receiver,

3) Insert a tape, 4) Turn off the VCR.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 95 96

Pas de commentaire

Sony SAT-A4 Manuel d'utilisateur Page 18