Sony DCR-IP220E Manuel d'utilisateur Page 103

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 296
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 102
103
Advanced Playback Operations Uitgebreide weergavefuncties
Opzoeken van een
gewenste opname aan de
datum – Datum-zoekfunctie
U kunt op een cassette met video-opnamen de
eerste opname van een bepaalde dag opzoeken
om de band automatisch vanaf dat punt weer te
geven (Datum-zoekfunctie).
Hiervoor gebruikt u de afstandsbediening.
Deze functie is handig om de overgangspunten
tussen de opnamedata op te zoeken of om
aanpassingen te maken bij elke opnamedatum.
Opzoeken van een
opnamedatum aan de hand van
het cassettegeheugen
(1)Zet de POWER schakelaar in de “VCR” stand.
(2)Druk enkele malen op de SEARCH MODE
toets van de afstandsbediening, totdat de
aanduiding “DATE SEARCH” oplicht.
Telkens wanneer u op deze toets drukt,
verspringt de zoekfunctie-aanduiding als
volgt:
TITLE SEARCH t DATE SEARCH
(geen aanduiding)
(3)Druk op de X of x toets van de
afstandsbediening om de opnamedatum voor
weergave te kiezen en druk dan op de
EXECUTE toets van de afstandsbediening.
Ook als u niet op de EXECUTE toets drukt,
begint toch automatisch het afspelen vanaf de
gekozen opnamedatum, twee seconden na
keuze van de datum.
[a] Punt waar u naar zoekt
[b] Huidige punt op de band
Stoppen met doorzoeken van de
band
Druk op de STOP toets van de
afstandsbediening.
Your camcorder automatically searches for the
point where the recording date changes and
starts playback from that point by selecting the
recording date (Date search).
Use the Remote Commander for this operation.
Use this function to check where recording dates
change or to edit the tape at each recording date.
Searching for the date by using
cassette memory
(1)Set the POWER switch to VCR.
(2)Press SEARCH MODE on the Remote
Commander repeatedly, until the DATE
SEARCH indicator appears.
The indicator changes as follows:
TITLE SEARCH t DATE SEARCH
(no indicator)
(3)Press X or x on the Remote Commander to
select the date for playback, then press
EXECUTE on the Remote Commander.
Searching the boundaries starts, and playback
automatically starts at the scene with the date
selected. Even if you do not press EXECUTE,
searching the boundaries starts automatically
in two seconds after you select the date.
[a] Actual point you are trying to search for
[b] Present point on the tape
To stop searching
Press STOP on the Remote Commander.
Searching a recording
by date
– DATE SEARCH
3
2
SEARCH
MODE
DATE SEARCH
15/9/02
26/9/02
3 24/12/02
41/1/03
5 13/ 2/ 03
6 29/ 4/ 03
DATE SEARCH
15/9/02
26/9/02
3 24/12/02
41/1/03
5 13/ 2/ 03
6 29/ 4/ 03
[b][a]
Vue de la page 102
1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 295 296

Commentaires sur ces manuels

Pas de commentaire